Jump to content
Welcome! ×
Atomic Mass Games Forum

New LOS rules

Recommended Posts




In its place the following bullet point should be considered added:

  • When determining line of sight from the following units, use the provided guidelines. Each ruling is used regardless of whether it is directly over the center of the base. 
    • DF-90 Mortar Trooper: Check from the top of the head of the shoretrooper who is firing the mortar.
    • E-Web Heavy Blaster Team: Check from the top of the head of the snowtrooper who is firing the E-Web.
    • LAAT/LE Patrol Transport: Check from the top of the cockpit glass where it meets the body of the LAAT.
    • TX-225 GAVw Occupier: Check from the center of the roof of the crew compartment.
    • Infantry Support Platform: Check from the angle of the middle support beam, between the two seats.
    • Raddaugh Gnasp Fluttercraft: Check from the top of the chassis, directly above the pilot miniature. 
    • TX-130 Saber-Class Fighter Tank: Check from the notch in the center of turret’s guard, which is above the front-most edge of the top hatch. 
    • AAT Trade Federation Battle Tank: Check from the point where the gun barrel meets the turret
    • DSD1 Dwarf Spider Droid: Check from the top of the spider droids body, where the base of the antenna meets the center of the miniature. 
    • NR-N99 Persuader-class Tank Droid: Check from the top of the body in the center of the wheel. 
    • STAP Riders: Check from the top of the head of the B1 unit leader.
    • A-A5 Speeder Truck: Check from the top of the front middle hatch.
    • AT-RT: Check from the top of the rider's head. 
    • T-47 Airspeeder: Check from the top of the cockpit glass.



If the direct line from the points specified above to the defending model goes through the attacking model is the target obscured I.E. the defending trooper in is base contact with a T-47, I'm assuming not but would just like a clarification. Thanks.

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Create New...